Remove terminal pins from a crimp housing
Steps
- Find the slot with the metal locking tab on the side of the housing.
- Press the tab down with a small screwdriver and pull the wire and pin out.
- Work one pin at a time, crimping a new Trifurcon pin on each wire before refitting it.
Systems
Related tips
- Reusing an IDC housing needs 08-52-0072 pins
- Discolored or heat-marked connector
- Unplug connectors by the housing
- Replace the 40-pin interboard female connector
- Resolder board header pins properly
- Resolder the driver board header pins
- Always replace the driver board's 40-pin female interconnector
- Resolder and inspect the driver board header pins
Source: Repairing Williams System 3 to System 7 Pinball 1977 to 1984, Part One, Clay Harrell (pinrepair.com)