Fitting a Fliptronics II board to The Addams Family
Steps
- Connect Fliptronics II J902, J903 (ribbon), J904, J905 and J906 where Fliptronics I had J802, J803, J804, J805 and J806 respectively.
- Fliptronics II J901 and J907 are left unused.
- On the power driver board unplug J111 and leave it disconnected; leave J109, J110 and J112 connected.
- Leave J901, J902 and J903 on the small flipper power board (backbox middle right) connected.
Systems
Games
Related tips
- Addams Family: fusing the magnets to protect the playfield
- GI string still dead after replacing J115: broken through-hole, add a jumper
- Won't start after a power surge, 5 V reads very low: failed C4 on the power driver board
- Getaway: beacon runs nonstop in test and driver board C11 overheats
- Addams Family: both right flippers stick up until the left button is pressed
- Fliptronics II board components
- Diagnosing a Fliptronics II board
- F101/F102 are idle on Fliptronic II games
Source: Repairing Williams/Bally WPC Pinball Games from 1990 to 1999, Part Two, Clay Harrell (pinrepair.com)